User's Manual

4. You may repeat steps 2 - 3 to program as many as 20 tracks.

5. Tap the PLAY/PAUSE

BUTTON to start the programmed play.

6. You may tap the PLAY MODE BUTTON repeatedly to select REP 1 or REP ALL

programmed tracks.

7. Tap STOP

BUTTON once to stop playback.

8. Tap the PLAY/PAUSE

BUTTON to resume programmed play.

9. To cancel programmed play and, press the STOP

BUTTON twice.

AUX IN OPERATION

You can play other music sources (iPod, MP3 or other digital audio players) through the

speakers of the JBS-215 by connecting the AUX IN JACK to your external player’s audio out

jack or headphone jack.

1. Plug one end of an audio cable (not included) into the AUX IN JACK and the other end of

the cable to the headphone jack of your digital audio player.

2. Tap SOURCE BUTTON to the AUX position.

3. AUX will show on the LCD DISPLAY.

4. Turn on and start playing the external device you plugged into the AUX IN JACK.

5. Slowly adjust both the volume controls of your JBS-215 and the external device until you

reach a comfortable listening level.

Notes:

• If you connect the JBS-215 to the Line-Out Jack of your external device, you only need

to adjust the VOLUME CONTROL of your JBS-215. If you connect to the Headphone

Jack of your external device, you may need to adjust both the volume controls of your

external device and the JBS-215 to obtain the desirable listening level.

• Remember to turn off the JBS-215 when you have finished listening. Don't forget to

switch off the power of your external audio device as well.

EARPHONES CONNECTION

Connect the plug of the stereo earphone (not included) into the EARPHONES JACK.

CAUTION

 Avoid excessive volume levels for long period of time when using the earphones.

Prolonged use at high levels may impair your hearing.

 Do not use earphones while operating a motorized vehicle, as it may create a traffic

hazard and is illegal in many areas

Tap EQ button to change EQ stage – Flat, Rock, Classic, Jazz and Pop

Note: EQ Flat stage is no indication.

DIMMER OPERATION

In standby mode, press and hole the SLEEP/DIMMER BUTTON repeatedly to select Low,

Medium or High brightness settings of the display.