Use and Care Manual

— 4 —
Installation
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE INSTALLING
Note: Use threaded drywall anchors only
when mounting the backsplash on sheetrock.
The backsplash installs to cover the wall space from the bottom of the hood to the cooktop/counter.
It can be installed during the installation of the hood or after.
If the hood is already installed, remove the hood lters, grease trays and lights and put in a safe
place. Then if necessary, remove the hood to allow installation of the backsplash.
Locate the midpoint of the hood at
the wall. Draw a vertical centerline
from this midpoint to the cooktop
(see Figure 1).
Open the packaging carefully to
avoid damaging the backsplash.
Position the backsplash on the wall,
centered on the marked centerline
and with lower edge ush with the
cooktop/counter.
•
•
•
1.
2.
3.
Mark where the screw holes are on the bottom and the top, drill
the holes and screw in the wall anchors.
Attach the shelf to the backsplash using the 11 supplied screws
ST4×8 (see Figure 2).
Fix the backsplash to the wall with screws on the bottom and
the top (see Figure 3).
Remove the plastic cover from backsplash once it’s xed to the
wall.
If necessary, replace the hood, with grease trays, lters and
lights.
4.
5.
6.
7.
8.
Figure 1 Figure 2
Figure 3