Instruction Manual Commercial Water Flowing Ice Maker Model: ICE-7020 2015-07-16 MAICE-7020-2
TABLE OF CONTENTS FEATURES.....................................................................................3 NOTES BEFORE OPERATION…………........................................3 STRUCTURE..................................................................................4 OPERATION PROCEDURES.........................................................5 MAINTENANCE..............................................................................6 TECHNICAL PARAMETERS…………….........................................
FEATURES Our ICE-7020 Commercial 20 kg Water Running Ice Maker is designed with a cubic shape that has a curved front panel and curved door (or stainless steel flat front panel and flat door) for a nice appearance. Many advantages of the ice maker are available such as: - Making ice quickly; - Great ice making capacity; - Nice ice shape; - Ice dropping quickly.
5. A space of about 150mm should be left around the ice maker to ensure proper ventilation. 6. Please adjust the feet when placing the ice maker, otherwise the water level and the shape of the ice will be affected. Before using the ice maker for the first time, you should wait about 12 hours after positioning it in a proper place. 7. The outlet of drainage tube should be lower than the cabinet, so as to drain water easily. 8. The separate three-pole outlet should be used and the grounding must be good.
OPERATION PROCEDURES 1. Unpack the ice maker from its carton, and then remove the ice shovel, inlet/outlet tubes, and sealing washers, from the container in the ice maker where they are packed for transit. 2. Position the ice maker on a well ventilated place, leaving at least a 150mm gap between the ice maker and the walls/ceiling etc. The ice maker must be level, and situated away from any heat source. 3. Attach one end of the φ12mm flexible plastic corrugated pipe to the water outlet on back of machine.
MAINTENANCE 1. If the compressor stops for any reason, due to a water shortage, too much ice, power off, or other reasons, don't restart it right away. Restart it 5 minutes later to protect the compressor. 2. On a regular basis, check the connectors of the water inlet and outlet tubes, and drain any surplus water that may occur. 3.
TROUBLESHOOTING Reference for Users and Technicians PROBLEM The ice marker does not work. Water shortage indicator lights on. Compressor doesn’t work. Compressor works, but no ice is made. REMEDY CAUSE 1.The voltage is out of the limitation. 1. Stop the ice maker and restart it until the voltage is normal. 2.The ambient temperature is lower than 10º C. 2. Try again when the ambient temperature is higher than 10ºC 1.Water shortage from the water supply system. 1. Check the water supply.
CIRCUIT DIAGRAM 8
