User Manual

— 17 —
Installation
STEP 12
Install Filters
To install lters, follow these four steps (See Figure #18):
r Angle the lter into slots at the back of the hood.
r Push the button on handle of the lter.
r Release the handle once the lter ts into a resting position.
r Repeat to install all lters.
Cleaning Filters
IMPORTANT: Drain oil from spacers, lters, oil tunnels, oil containers before oil and residue overow!
r Remove all spacers, lters, grease tray, and oil containers and discard oil and residue.
r Wash with warm soapy water. NOTE: Stainless steel lters, spacers and oil tunnel are top rack dishwasher safe.
r Dry thoroughly before replacing and follow directions for installation in reverse.
r Filters should be cleaned after every 30 hours of use.
r Should lters wear out due to age and prolonged use, replace with a new lter.
Figure #18