User Manual

— 16 —
STEP 11
Venting
r Depending on exterior ventilation chosen (see page 10), either exit the ducting through the ceiling or wall.
r "MXBZTVTFSJHJEUZQFNFUBMBMVNJOVNEVDUUVCFGPMMPXUIFCVJMEJOHDPEFTJOZPVSBSFBUPNBYJNJ[FBJSáPX.BLFTVSF
UIBUUIFCBDLESBGUáBQTDBOPQFOUPBMMPXNBYJNVNBJSáPX$POOFDUUIFEVDUUVCFUPUIFWFOUEBNQFSBOETFDVSFMZ
seal with certified aluminum or foil tape so that it is airtight. Please check the building codes in your city to learn which
tape product is recommended.
r Connect ductwork to damper. Use Duct Tape to ensure joint is sealed and airtight.
IMPORTANT:
r 0CTFSWFBMMHPWFSOJOHDPEFTBOEPSEJOBODFT
r It is the customer’s responsibility to contact a qualified electrical installer.
r *GDPEFTQFSNJUBOEBTFQBSBUFHSPVOEXJSFJTVTFEJUJTSFDPNNFOEFEUIBUBRVBMJGJFEFMFDUSJDJBOEFUFSNJOFUIBU
UIFHSPVOEQBUIJTBEFRVBUF"7PMU)["$POMZGVTFEFMFDUSJDBMTVQQMZJTSFRVJSFEPOBTFQBSBUFBNQ
circuit, fused on both sides of the line.
r %0/05HSPVOEUPBHBTQJQF
r $IFDLXJUIBRVBMJGJFEFMFDUSJDJBOJGZPVBSFOPUTVSFUIBUUIFSBOHFIPPEJTQSPQFSMZHSPVOEFE
r %0/05IBWFBGVTFJOUIFOFVUSBMPSHSPVOEDJSDVJU
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
r 5IJTBQQMJBODFNVTUCFHSPVOEFE*OUIFFWFOUPGBOFMFDUSJDBMTIPSUDJSDVJUHSPVOEJOHSFEVDFTUIFSJTLPGFMFDUSJD
shock by providing an escape wire for the electric current.
WARNING: Improper grounding can result in a risk of electric shock.
r $POTVMUBRVBMJGJFEFMFDUSJDJBOJGUIFHSPVOEJOHJOTUSVDUJPOTBSFOPUDPNQMFUFMZVOEFSTUPPEPSJGEPVCUFYJTUTBTUP
whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,
have a qualified electrician install an outlet near the appliance.
r 5IFSBOHFIPPENVTUCFDPOOFDUFEXJUIDPQQFSXJSFQMVHPOMZ5IFSBOHFIPPETIPVMECFDPOOFDUFEEJSFDUMZUP
the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/
CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-
connection kits that have been investigated and found acceptable for use with this model.
Installation