Use and Care Guide

—2 —
Required Tools
Before You Begin
Unpack the towel warmer carefully to avoid any damage or loss of any part. When opening the box, care should be taken to
not discard packet of mounting screws. It is your responsibility to immediately inspect for any damage. Shipping damage
should be reported immediately to your place of purchase.
Follow instructions to make sure your towel warmer is properly installed. FAILURE TO FOLLOW THESE STEPS COULD
RESULT IN HAZARDOUS CONDITIONS.
To avoid possible re hazard, the Towel Warmer must be mounted as intended. MOUNT THIS UNIT AS SHOWN IN THESE
INSTRUCTIONS.
The towel warmer must be used in accordance with any prevailing code and relevant electrical wiring rules and regulations, in
particular regulations that cover the use of products and accessories in damp situations such as showers, laundries and other
areas with xed water containers.
•
•
•
Towel Warmer must be mounted vertical with cord in position as shown. No other position is safe or recommended.
To provide continued protection against the risk of electrical shock, connect to properly grounded outlet only.
Towel Warmer must be securely mounted to the wall. When possible, the Towel Warmer should be attached to adequate
blocking or framing. Installations where blocking or framing is not available, must use appropriate wall anchors for mounting
directly to sheetrock.
CAUTION:
1. Approved for domestic use only. Do not use
outdoors.
2. Install in accordance with national and local codes.
3. Do not install in the shower, sauna or any wet
locations.
4. Make sure towel warmer is properly secured to the
wall before use.
24 in.
Shower/Tub
Zone
Do not locate the
towel warmer within
the shower/tub zone
For illustrative purposes only
0.6 m
•
•
•
Failure to follow the installation instructions may lead to overheating and malfunction.
Any repairs that involve opening the Towel Warmer must be carried out by manufacturer or their
representative.
Please contact your supplier in the event of any problem or if repair is needed.
Electrical requirements: 120V, 140W, 60Hz, 1.167A. MUST HAVE A GROUND CONNECTION.
Should be protected by a 15 amp GFI circuit breaker or equal.
READ ALL INSTRUCTIONS IN THE MANUAL BEFORE INSTALLING THIS TOWEL
WARMER.
FLAT HEAD SCREWDRIVERSSTARHEAD SCREWDRIVERS
PENCIL
DRILL & BIT
LEVEL
MEASURING TAPE
5/16” Diameter