Use and Care Manual
Operation and LED Indication
•
•
•
•
•
•
Quick blinking green: Connecting to the network.
Slow blinking green: AP mode.
Green bright after 2 seconds off: Connected to the network.
Solid green: Network working normally or in standby mode.
Solid blue: The Wi-Fi switch is switched on.
Off: The Wi-Fi switch is switched off.
Federal Communication Commission Interference
Statement
FCC Compliance Statement
— 5 —
— 6 —
Warranty Information
AMS warrants its products to be free of defects in materials and workmanship
for a period of one (1) year. There are no obligations or liabilities on the part of
AMS for consequential damages arising out of or in connection with the use
or performance of this product or other indirect damages with respect to loss
of property, revenue, or prot, or cost of removal, installation or reinstallation.
Limited Product Warranty shall be automatically void if: (i) any repair,
alteration, modication, customization, disassembling, addition or any other
work is performed on the Product by any person not authorized by AMS to do
so; (ii) any alleged material defect, including deterioration or wear, is a result
of failure to observe the manufacturer’s instructions or guidelines, abuse,
misuse, improper operation, care or maintenance, unusual physical or
electrical stress and/or power surges, brown-out, chemical abrasion or
improper chemical or environmental conditions, leaking, re, lightning, force
majeure or superior force, accident, error, negligence, or is a result of use for
nondomestic or non-residential purposes or for any purpose other than the
Product’s intended purpose; (iii) the Product is operated in conjunction with
accessories, other products, ancillaries or peripheral equipment or
substances that have not been previously approved in writing or validated by
AMS; or (iv) Purchaser fails to comply with the Warranty Claim Procedure.
20201211
This equipment has been tested and found to comply with the limits for a class B
Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment uses, generates and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1.
2.
This device may not cause interference, and
This device must accept any interference received, including interference that
may cause undesired operation.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 cm between the radiator and your body.
RF Exposure: A distance of 20 cm shall be maintained between the antenna and
users, and the transmitter module may not be co-located with any other
transmitter or antenna.
Non-modification Statement
Any changes or modications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
MAPA-TM-WF-01-03
www.anconahome.com