Use and Care Guide
Hardwire Installation
Step 3: Marking holes for wall mount posts (Fig. 3)
Step 4: Installing wall posts (Fig. 4)
h
— 4 —
- Take towel warmer with four (4) Metal Wall Legs mounted, as per Step 2.
- Position against the wall where you will want to install the towel warmer.
- Ensure the Hard Wire Leg is also turned in at 90 degrees so you can also mark this leg.
- Use light pencil to mark legs on the wall (you may want to erase the pencil mark following installation completion, so make
sure you mark lightly).
Fig. 3 Fig. 4 Fig. 5 Fig. 6
If installing on dry wall with no rear beam support (e.g. wood studs):
o Drill a hole in the center of each of the four (4) circles marked on the wall as per Step 3.
o Ensure the drilled hole is large enough to insert the Plastic Plug provided a.
o Insert/screw the Plastic Plug into each of the four (4) holes.
o Position Wall Post b on top of Plastic Plug and put in Screw c to set in place.
If installing on surface with rear support, e.g. wood studs (no need for Plastic Plug a):
o Pre-drill small hole in the center of each circle as per step 3.
o Position Wall Post b on top of pre-drilled hole and put in Screw c to set in place.
Step 5: Installing hard wire leg (Fig. 5)
- Create a hole in the wall to let the Hard Wire Leg go through (approx. 2 in. x 3 ¾ in.).
- The leg will be covered by Plate h so the hole should be large enough to allow space for electrical connection and leg to go
through but not too large so that the plate can cover it fully.
- Electrical wiring must be done by qualied professionals and in accordance with all applicable codes and standards, including
re-rated constructions (refer to Electrical Requirements on Page 2).
Step 6: Mounting main body onto wall (Fig. 6)
- Take main body and position each of the four (4) legs on top of the Wall Posts b.
- Once inserted use appropriate sized Allen key to tighten each Set Screw g.
- The installation should now be complete.
Step 7: Test the towel warmer
- Remove protective white caps, they are located at the end of each of the vertical bars.
- Turn the switch on to start towel warmer; the On-Off switch is located at the end of one of the posts.
- The towel warmer should reach its pre-set temperature in approximately 15 minutes.
- This towel warmer is designed to operate continuously and can be left on all the times. To save electricity it can be turned off
when not in use.