Full Product Manual

ManualsBrandsAncona ManualsBathComfort 7 Series 7-Bar 31 in. Hardwired Electric Towel Warmer in Oil Rubbed Bronze

Comfort 7 Towel Warmer

User Manual

Installation Instructions

IMPORTANT SAFETY INSTRUCTIONS

Carefully read the important information

regarding installation, safety and maintenance.

Keep these instructions for future reference.

MAAN5317-04

2020-08-24

Summary of content (6 pages)

PAGE 1
Comfort 7 Towel Warmer User Manual & Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Carefully read the important information regarding installation, safety and maintenance. Keep these instructions for future reference.
PAGE 2
Required Tools STARHEAD SCREWDRIVERS FLAT HEAD SCREWDRIVERS DRILL & BIT MEASURING TAPE 5/16” Diameter LEVEL PENCIL Electrical requirements: 120V, 112W, 60Hz, 0.93A. MUST HAVE A GROUND CONNECTION. Should be protected by a 15 amp GFI circuit breaker or equal. READ ALL INSTRUCTIONS IN THE MANUAL BEFORE INSTALLING THIS TOWEL WARMER. Before You Begin Unpack the towel warmer carefully to avoid any damage or loss of any part.
PAGE 3
Product Dimensions Parts for Hardwire Wall Mount Installation a b c Plastic plug 4 + 1 pieces Ø 8 mm Wall Post 4 pieces Screw 4 + 1 pieces d e f Metal Wall Leg 4 pieces Large Screw 4 + 1 pieces Plastic insert 4 pieces g h i Set Screw 4 + 1 pieces Plate 1 piece j k Small Allen Key 1 piece Large Allen Key 1 piece Wall Plate Screws 2 + 1 pieces Figure 1 Hardwire Installation Step 1: Verifying installation parts (figure 1) Ensure all parts for mounting installation were supplied with your
PAGE 4
Hardwire Installation Step 3: Marking holes for wall mount posts (Figure 3) - Take towel warmer with four (4) Metal Wall Legs mounted, as per Step 2. - Position against the wall where you will want to install the towel warmer. - Ensure the Hard Wire Leg is also turned in at 90 degrees so you can also mark this leg.
PAGE 5
Operation and Maintenance Instructions • • • • After installation, connect the electric power and turn on the switch. The indicator light will show red and the towel warmer will start to work. Turn off the switch when the towel warmer is not in use. The indicator light will turn dark and the towel warmer will stop working. When cold, clean the towel warmer with a soft dry towel. Do not clean with abrasive cleaning powder. Unplug the unit if not in use for a long period of time.
PAGE 6
Please register your product warranty by visiting the Ancona Home website. Canada & USA Phone: 1-800-350-4562 Fax: 800-350-8563 Email: service@anconahome.com Website: www.anconahome.