Installation Guide

Faucet Installation
3
Installation size map
Step 2: Secure Spout Body in place:
C. Insert black rubber ring into the metal ring.
D. Insert the metal ring in between bottom of
faucet body and sink deck hole.
E. Insert faucet body through sink deck hole.
Step 4: Securing all connections:
H. Connect supply hoses to main water
supply.
I. Ensure all connections are tight to avoid
potential leakage.
7.6 cm
(3 in.)
Faucet Installation
1
Preparation: Turn off water supplies and
drain water lines. Clean installation site
and remove any debris from the area.
Step 1: Connect Supply Hoses:
A. Screw supply hoses and into base of
faucet body.
B. Screw in steel post into base of faucet
body.
2
Step 3: Insert Rubber and Metal washers:
F. Slide black rubber washer and metal washer over
steel post, so that they fit around supply hoses.
G. Insert nut onto steel post.
4
9.8 cm (3.8 in.)
16.5 cm
(6.5 in.)
Ø 4 cm
(1.5 in.)
Ø 2 cm
(0.8 in.)
14.1 cm (5.5 in.)
11.1 cm (4.3 in.)
Ø 3.5 cm (1.3 in.)
2-9/16 in.
Max 4.5 cm