OWNER’S MANUAL
INSTALLATION INSTRUCTIONS General Recommendations: Read installation and maintenance instructions, thoroughly before installation. Be sure to use proper tools and always wear personal safety accessories for your protection. Warning: The enclosed cut-out template is provided as a guide only and should be checked against actual sink to determine correct fit. Metal edges may be sharp. Use gloves when handling. Long-Life Care Ancona Stainless Steel Sinks are easy to keep looking new, longer with minimal care.
TOP-MOUNT INSTALLATION Please carefully read complete instructions before beginning installation. Note: These instructions are for installation with solid surface, composite material countertops. Ancona recommends professional countertop installers, customer is responsible for damage to the countertop or sink during installation. 1. Unpack the new sink and check the contents of the materials supplied: sink, mounting brackets, and cut-out template (depending on model). 2.
TOP-MOUNT INSTALLATION 5. Attaching the mounting clips: Attach the top-mount clips (AA) to the sink (A). Turn screws towards the left. 6. Installing the sink: - Apply silicone sealant (not included) around the underside and lip of the sink (A). - Carefully lower the sink (A) into the counter. - Tighten the screws on the top-mount clips (AA) evenly until the sink (A) is flush with the counter. Do not over-tighten. - Wipe excess sealant with a rag. 7.
UNDERMOUNT INSTALLATION Please carefully read complete instructions before beginning installation. Note: These instructions are for installation with solid surface, composite material countertops. Ancona recommends professional countertop installers, customer is responsible for damage to the countertop or sink during installation. 1. Unpack the new sink and check the contents of the materials supplied: sink, mounting brackets, and cut-out template (depending on model). 2.
UNDERMOUNT INSTALLATION 8. Clean underside of the countertop and around cut-out area, making sure area is smooth and free of defects. 9. Apply a bead of sealant to the rim of sink, near the inside edge. Be careful not to miss or skip any area. 10. Carefully lift sink squarely under counter top cut-out. Press firmly on sink to form seal and seat sink. Using a damp cloth, immediately wipe any excess sealant from edge of sink. Do not smear or spread any excess sealant on counter top or sink. 11.
CARE AND MAINTENANCE ALWAYS: - Clean everyday by thoroughly rinsing with a mild soap and warm water and wipe dry. Some chemicals such as chlorides may corrode stainless steel, make sure you rinse the surface immediately. - Rub lightly with a soft cloth in the direction of grain lines on a regular basis for additional preventive cleaning. - Keep the sink free of any standing water as this can cause a buildup of mineral deposit, which can affect the appearance of your sink.
