Installation Guide

— 13 —
STEP 8
Venting
• Fix the damper ap into the damper hole on top of the range hood motor box. (See Fig. #3)
• Let the ducting pipe go inside through the hole from the ceiling. (See Fig. #4)
• Measure the length of 6`` round metal duct required from the dampler / duct connector to the ductwork rough-in in the
ceiling. Connect the duct to the damper / duct connector and seal with duct tape.
Fig #3 Fig #4
STEP 9
Electrical
• Use the supplied `S` hook to hold up the chimneys while feeding the electrical wires. (See Fig. #5).
• Remove the protective coating from the inner chimney. Carefully slide the inner chimney down into the outer chimney.
Slide the chimneys over the angle brackets.
• Feed the electrical wires up through the chimneys. (See Fig. #6)
• Connect the electrical wires to the wiring box on the ceiling bracket.
.................
.................
Fig #5 Fig #6
Electrical wires
Installation