Full Product Manual

— 15 —
Installation
STEP 11
Install Filters
• Angle the lter into the slots at the back of the hood.
• Open handle on the lter.
• Release the handle once the lter ts into a resting
position.
• Repeat to install all lters.
• The lters channel grease released by cooking foods
andpreventamingfoodsonthecooktopfrom
damaging the inside of the range hood. For this
reason, the lters must ALWAYS be installed during
range hood use.
• The lters should be cleaned once a month, or as
needed. See page 17 for cleaning instructions.
IMPORTANT:
• Observeallgoverningcodesandordinances.
• It is the customer’s responsibility to contact a qualified electrical installer.
• Ifcodespermitandaseparategroundwireisused,itisrecommendedthataqualifiedelectriciandeterminethat
thegroundpathisadequate.A120-Volt,60Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-amp
circuit, fused on both sides of the line.
• DONOTgroundtoagaspipe.
• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.
• DONOThaveafuseintheneutralorgroundcircuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric
shock by providing an escape wire for the electric current.
•Therangehoodmustbeconnectedwithcopperwireonly.
•Therangehoodshouldbeconnecteddirectlytothefuseddisconnect(orcircuitbreaker)boxthroughflexible
armored or non-metallic sheathed copper cable. UL/CSA listed strain relief must be provided at each end of the
power supply cable.
WARNING: Improper grounding can result in a risk of electric shock.
• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto
whether the appliance is properly grounded. DO NOT use an extension cord.
Figure #10