Full Product Manual

— 14 —
STEP 10
Finishing Installation
Note: To avoid personal injury and/or damage to the range hood, this
installation step requires three people.
Installation
Figure #7
Figure #8 Figure #9
.................
.................
Figure #6
• Use 4 pieces ST4 × 8 mm mounting screws to attach the upper chimney into the hanging board and hold up the lower
chimney with the supplied `S` hook (see Figure #6).
• Use 16 pieces M4 × 10 mm mounting screws to attach the hood into angle irons (see Figure #7).
• Attach the ducting pipe on the outlet (see Figure #8).
• After nishing all the above installation steps, remove the `S` hook
and put down the lower chimney (see Figure #9).