Instructions / Assembly

INSTALLATION:
SAFETY WARNING:
Risk of electrical shock. This range hood must be properly grounded. Make sure this is
done by a qualified electrician in accordance with all applicable national and local
electrical codes. Before connecting wires, switch power off at service panel and lock
service
panel to prevent power from being switched on accidentally.
Step 4: Installing the hood
• Remove the filters, halogen lights and the range hood cover. (See Fig #4)
• Align range hood to the opening in the bottom of the cabinet and screw in using the screws
provided. See Fig #4)
Step 5: Venting
• Depending on the exterior venting chosen (See Page 7), either exit the ducting through the
ceiling or wall.
• Always use rigid type metal/aluminum duct tube (following the building codes in your area)
to maximize airflow.
• Make sure that the backdraft flaps can open to allow for maximum airflow. Connect the
duct tube to the vent/damper and security seal with duct tape so that it is air tight.