Use and Care Manual
— 16 —
Metal bracket 
Socket
Lightbulb
2 Entryway
for bulb 
Prongs
Socket
Bulb with 
prongs
This range hood uses halogen bulbs: 
20 W 120 V Type MR16 GU10
Maintenance
Removing old lightbulbs
u
  Make sure the range hood is unplugged or turn OFF 
breaker. 
v
  Remove lters. Reach into interior of range hood 
and place one hand above the metal bracket and 
with two ngers gently push down on the socket 
area. (See Fig #6).
CAUTION: BULB MAY BE HOT, PLEASE TAKE 
OUT THE BULB WHEN THE BULB IS 
COMPLETELY COOL!
Note: Range hood and Lightbulbs may have very sharp 
edges; please wear protective gloves if it is necessary 
to remove any parts for installing, cleaning or servicing.
w
  So as not to accidently break the glass, gently 
place two ngers from second hand onto the 
surface of the light bulb. (See Fig #6) Gently turn 
the lightbulb counter clockwise to loosen and 
unlock lightbulb from socket. Once unlocked the 
lightbulb should come out freely. 
Installing new lightbulbs
u
  With your new lightbulb in one hand, ensure the 
bulb prongs are lined up with the wide ends of the 
two slots located in the socket.
v
  Slip light bulb into the wide ends of the two slots 
and turn clockwise until a locked position is 
apparent. (See Fig #7) 
Note: Do not push too hard as the light bulb prongs may 
break off.
w
  Turn ON electrical breaker and range hood to test 
for operation. 
Replacing the Light Bulbs
 IMPORTANT:
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY AT THE MAIN PANEL BEFORE CARRYING OUT ANY OPERATION 
ON THE APPLIANCE.
Fig #6 Fig #7
Cleaning Filters
IMPORTANT: Drain oil from spacers, lters, oil tunnels, oil containers before oil and residue overow!
• Remove all spacers, lters, grease tray, and oil containers and discard oil and residue.
• Wash with warm soapy water. NOTE: Stainless steel lters, spacers and oil tunnel are top rack dishwasher safe.
• Dry thoroughly before replacing and follow directions for installation in reverse.
• Filters should be cleaned after every 30 hours of use.
• Should lters wear out due to age and prolonged use, replace with a new lter.










