Use and Care Manual

— 11 —
Installation
STEP 6
Preparations
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
• Determine and mark the centre line on the ceiling or wall where the range hood will be installed.
• Make sure there is proper clearance within the ceiling or wall for exhaust vent.
• Duetotheweightandsizeofthisunit,pleasemakesurethatthesupportsystemorframeworkbeingusedisstableand
secure in the ceiling or wall.
• Put a thick, protective covering over counter top, cooktop or range to protect from damage or dirt.
• Removeanyhazardousobjectsaroundtheareawheninstalling.
CAUTION
If moving the cooking range is necessary to install the hood, turn OFF the power on an electric range at the main
electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
Fig #1
STEP 7
Preparing the cabinet
• Measure and cut an opening at the bottom of the cabinet
to t the motor box of the range hood. (See Fig #1)
• Measure and cut a hole in the top of cabinet to t the duct
tube. (See Fig #1)
• Note that the hole in the top of the cabinet may not be
necessary depending on venting method chosen. (See
Page 10).
STEP 8
Attaching damper
• Attach the vent/damper to the top of the motor using
supplied screws. (See Fig #2).
Fig #2
Cut-out dimensions:
28 in.: 26.25 in. x 10.25 in.
(67 cm x 26 cm)
36 in.: 34.25 in. x 10.43 in.
(87 cm x 26.5 cm)
For consumer safety reasons, mounting
screws and anchors have not been supplied
with this range hood. Different wall and
cabinetry construction methods require
specic types of screws and wall anchors.
Please consult your installation specialist
regarding the best type of mounting screws
and wall anchors to suit your home’s
construction.