Installation Guide

Page 14

If the range hood or LED light does not operate Ŗ Check if the range hood has been plugged in, make

sure that all power has been turned back ON, fused

not blown and all electrical wiring are properly con-

nected.

Swap out light assembly to working ones to deter-

mine whether it is caused by defective bulbs. See

Replacing the Light Bulbs on Page 22.

2. The range hood vibrates when the blower is on: Ŗ The range hood might not have been secured prop-

erly on to the ceiling or wall.

3. The blower or fan seems weak: Ŗ Check that the duct sized used is at least 7” or 3-1/4

x 10”. Range hood WILL NOT function efſciently

with insufſcient duct size. For example: 8” duct

over 7” hole and loosely secured.

Ŗ Check if duct is clogged or if damper unit (half-cir-

cular ƀapper) is not installed correctly or opening

properly. A tight mesh on a side wall cap unit might

also cause restriction to the air ƀow.

4. The lights work but the blower is not spinning at all, Ŗ

is stuck or is rattling.

The blower might be jammed or scraping the bot-

tom due to shipping damage. Please contact us im-

mediately.

5. The hood is not venting out properly: Ŗ Make sure the distance between the stove top and

the bottom of the hood is within 24” and 30” in

distance; with minimum 30” for gas stove top.

Ŗ Reduce the number of elbows and length of duct

work. Check if all joints are properly connected,

sealed, and taped.

Ŗ Make sure the power is on high speed for heavy

cooking.

after installation:

Troubleshooting :