Installation Guide

Page

Advanced Preparations:

Ŗ Be familiar with the controls of the range hood by

reading through Range Hood Operations, Page 12.

Ŗ Place the range hood on a ƀat, stable surface.

Connect the range hood to a designated standard

outlet (120-Volt, 60Hz, AC only) and turn on the

range hood. Verify all operations of the range hood by

referring to Range Hood Operations, Page 13.

Ŗ Place all supplied parts and required hardware on a ƀat, stable surface and verify

the existence of all supplied parts listed on Page 4.

Ŗ Carefully remove the white plastic protective coat from the range hood.

Preparations:

NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.

Ŗ Decide the location of the venting pipe from the hood to the outside. Refer to Venting Methods on Page 7.

Ŗ A straight, short vent run will allow the hood to perform more efſciently.

Ŗ Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the

hood.

Ŗ IMPORTANT: Peel white plastic protective coat off the hood, if any.

Ŗ Use silver tape or duct tape to seal joints between pipe sections.

Ŗ For installing under the cabinet with recessed bottom, attach 4-inch wide wood ſller strips (not provided) on

each side. Refer to Figure 1.

Ŗ Using references in Measurements and Diagrams on Page 16, create access opening for electrical wires and

hood exhaust under the cabinet.

CAUTION: If moving the cooking range is necessary t o install the hood, turn OFF the power on an

electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

Ŗ Puncture the knockout holes (for mounting under the cabinet) on the hood as shown in Figure 2.

Ŗ If necessary, attach two rubber stands with 3M adhesive tapes to the back corners of the hood.

2 e r ug i F 1 e r ug i F

Preparation :