Use and Care Manual

— 14 —
Installation
Top venting using rectangular damper:
• If you require rectangular top (vertical) venting, simply install the rectangular damper provided (See Fig #7, #8 and #9).
Use four screws (ST4 x 8 mm) to connect 10 inch damper or eight screws (ST4 x 8 mm) for 14 inch damper.
Rear venting (horizontal) using rectangular damper:
• Ifyourequire10inchor14inchrectangularrear(horizontal)venting,simplyinstalltherectangulardamperprovided.See
Fig #10, #11 and #12 to remove plate, use four screws (ST4 x 8 mm) for 10 inch duct, or eight screws (ST4 x 8 mm) for
14 inch duct to connect damper.
Fix rectangle damper to the back by
four screws (ST4 x 8 mm) 10 inch
duct, or eight screws (ST4 x 8 mm)
14 inch duct.
Fix rectangle damper to the top
by four screws (ST4 x 8 mm)
for 10 inch or eight screws
(ST4 x 8 mm) for 14 inch.
Fig #7 Fig #8
For 10 inch rectangular vent, keep these two parts.
For 14 inch rectangular vent, punch and remove as well.
For 10 inch rectangular vent, keep these two parts.
For 14 inch rectangular vent, punch and remove as well.
Fig #12
Fig #10 Fig #11
Fig #9