Installation Guide

REPLACEMENT INSTALLATION:

ep 5: Venting

Step 1: Measuring

• Measure the distance between the cooking surface and the bottom of the range hood. A distance of

24” to 30”.

Step 2: Preparing The Hood

• Remove the unit from packaging. Position the unit on a flat non-abrasive surface.

• Remove the 2 filters and easy-clean panel to allow access to the inside of the unit. (See Fig #1 to #3)

g # 4

Fig #2

Step 3: Attaching Vent/Damper

• Depending on the exterior venting option chosen (See page 7), pop out the steel panel on either the top or

rear of the range hood (See Fig #4)

•

Using the supplied screws, attach the rectangular vent/damper to the top or rear of the range hood. (See Fig #5)

g # 4

Fig #4

Fig #5

Installations (refer to Page 4 for parts):

NOTE: Use threaded drywall anchors only when

mounting the hood on sheet rock. Mounting the hood

on wall studs or lumbars is highly recommended.

Fig #1

Fig #3