Installation Manual

— 16 —
u
Make sure the electrical power to the range hood is
turned off. Please note that the light bulbs may be
hot . Allow enough time to let the light bulbs cool off
before attempting to change them.
v
Attach the black rubber suction piece, included
with your range hood, to the outside glass part of
the bulb. Press the bulb inwards. DO NOT push too
hard as bulb “legs” may break off. (See Fig #8)
w
Turn the bulb counter-clockwise as you continue to
press inward. Release your pressure on the lamp
when it won’t turn any farther. Gently pull the bulb
straight out of the socket. You may need to wiggle it
gently to get the cylindrical “feet” aligned correctly
with the larger openings in the socket. (See Fig #9)
x
Discard the old bulb. Line the prongs on the new
bulb up with the wide openings on the socket. Press
inward on the edges of the new lamp with your
thumbs and twist the lamp clockwise as far as it will
go.
y
Turn the electricity and range hood on and test for
operation.
Maintenance
Replacing the Light Bulbs
IMPORTANT:
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY AT THE MAIN PANEL BEFORE CARRYING OUT ANY OPERATION
ON THE APPLIANCE.
This range hood uses halogen bulbs: 35W 120V Type GU-10
Fig #8 Fig #9