Installation Guide

— 16 —
Installation
STEP 7B (cabinet hoods only)
Attaching Vent/Damper
• Remove the two lters to allow access to the inside of
the unit.
• Depending on the exterior venting option chosen (See
page 12), pop out the steel panel on either the top or
rear of the range hood. (See Figure #8)
• Using the supplied screws, attach the rectangular vent/
damper to the rear of the range hood. (See Figure #9)
STEP 9B (cabinet hoods only)
Electrical Connection
• Use the tool to punch the wiring hole, from the
two options for holes. Please choose Fig. #11-1
hole or Fig. #11-2 hole accordingly to wiring
requirement.
• Connect cable to range hood wiring. (See Figure #12)
• Connect BLACK to BLACK, WHITE to WHITE and GREEN to GREEN.
• DON’T FORGET TO CONNECT THE GROUND! (green wire)
• The terminal is not provided, it should be prepared by a qualied electrician.
• WARNING: ALL CONNECTORS MUST BE ENCLOSED IN THE WIRING
COMPARTMENT.
SAFETY WARNING: Risk of electrical shock. This range hood must
be properly grounded. Make sure this is done by a qualied electrician
in accordance with all applicable national and local electrical codes. Before
connecting wires, switch power off at service panel and lock service panel to
prevent power from being switched on accidentally.
STEP 8B (cabinet hoods only)
Installing the Hood
• Using measurements provided on page 7, measure and drill 4 holes into bottom
of cabinet. (See Figure #10)
• Depending on exterior venting chosen (See page 12, use measurements
provided on Page 7) and cut vent hole in cabinet.
• Align range hood to the holes in the bottom of the cabinet and screw in. (See
Figure #10)
Fig. #10
Note: Use threaded drywall anchors only when mounting the hood
on sheet rock. Mounting the hood on wall studs or lumbers is highly
recommended.
Fig. #8 Fig. #9
Fig. #12
Fig. #11-1 Fig. #11-2