Installation Guide

— 14 —
Installation
STEP 10A (wall hoods only)
Mount Range Hood onto Wall
• Hang the range hood on the hooks of the hood mounting bracket.
(See Figure #4)
• Screw the range hood to the wall.
CAUTION - Make certain the range hood is secure before
releasing!
STEP 9A (wall hoods only)
Venting
• Fixthedamperaponthetopventofhood.
• If ventilation system is equipped with an external air duct with a different
diameter, apply a reduction tting. However, for maximum performance
and safety, a 6 in. round ducting is recommended. (See Figure #3)
Fig. #3
Fig. #4
STEP 11A (wall hoods only)
Connect Ductwork
• Attach ductwork to duct. Secure the ductwork with duct tape to make sure joints are secure and air- tight.
• Donotinstalltheducttapetootightlyasthismaypreventthedamperapsfromopeningwhichwilloverworkthemotor
and cause improper functioning of the unit.
• Fasten all connections with sheet metal screws and tape all joints with certied aluminum or foil tape. Use caulking to
seal exterior wall or roof opening around the cap.
STEP 12A (wall hoods only)
Connect to AC
• ConnectACplugintoagroundedACoutlethaving120V,60Hz.Placetheoutletatamaximumdistanceof33-1/2in.
(851 mm) from where the cord exits on the hood.
• SEE IMPORTANT INSTRUCTIONS ON NEXT PAGE.
3-Pronged Plug
Ground Plug
3-Prong Receptacle
• Optional step: For extra support, drill 2 additional holes aligned
to hood’s pre-drilled holes, to mount the hood onto the wall. (See
Figure #2)
Fig. #2