User Manual

ManualsBrandsAnchor ManualsSports and recreationEVENT AND VENUE LINER

LEV 0413EC4665

Liner Installation Instructions

for Event & Venue Series

Anchor Structures

SALES OFFICES:

1100 BURCH DRIVE

PO BOX 3477

EVANSVILLE, IN 47733 USA

PRODUCTION FACILITIES:

EVANSVILLE, IN

PHONE: 812-867-2421

FAX: 812-867-0547

1-800-544-4445

E-MAIL: tents@anchorinc.com

www.anchorinc.com

Liner for Mid

Gable End Liner

with Mid Attached.

Important: Read these instructions BEFORE frame assembly.

Note: If there is no access to the bottom rafter kedar channels, kedared buckles must be inserted into the

appropriate channels BEFORE rafters are attached to frame. See step 9 for instructions. Disregard if there is

access to the bottom rafter kedar channels.

Eave cables must be attached to uprights. This may be done just prior to liner installation. See step 5.

Summary of content (8 pages)

PAGE 1
Liner Installation Instructions for Event & Venue Series Anchor Structures Liner for Mid Gable End Liner with Mid Attached. Important: Read these instructions BEFORE frame assembly. Note: If there is no access to the bottom rafter kedar channels, kedared buckles must be inserted into the appropriate channels BEFORE rafters are attached to frame. See step 9 for instructions. Disregard if there is access to the bottom rafter kedar channels. Eave cables must be attached to uprights.
PAGE 2
Ridge Insert Weldment Ridge Insert Weldment upright bracket Liner Liner SIDE VIEW Step 1 FRONT VIEW Bolt with eyenut thru peak weldment upright location. Figure 1 Ridge Insert Weldment The liner will be hoisted by ropes attaching to eyenuts that are attached to the peak weldment upright location as shown in Figure 1. It will be easier to install these bolts and eyenuts if it is done before the frame is raised or the fabric is installed.
PAGE 3
Step 3 Join pieces together with Velcro, menax fasteners and side release buckles at ridge and eaves. (Figures 3a and 3b) Figure 3a Menax fastener Velcro at edges of liner mids. Figure 3b Step 4 Feed each ridge kedar into channel of liner ridge tube.
PAGE 4
Step 5 - For Event Eave cables with turnbuckles are required for liner installation. Slide the Liner Eave Bracket onto the interior side of the upright. Fasten by tightening screw and eyebolt into upright channels as shown below. Attach quick link and cables as shown in Figure 5b. See Figure 5c for Gable End Cable attachment. Twist Turnbuckles until cables are taut. Eave Purlin Rafter Quick link Mid Liner Cable (2) Eyebolts and (1) screw are included with each bracket.
PAGE 5
Step 5 - For Venue Eave cables with turnbuckles (Figure 5f) are required for mid liner installation. Loosen nuts and bolts at location shown in Figure 5e, slide L-bracket in place and tighten bolts. Adjust turnbuckle until cable is tight. L-Bracket Quick Link Mid Eave Bar Gable end L-Bracket Cables for mid fastens into L-Bracket Figure 5e Turnbuckle Step 6 Attach quick links and tie pull rope as shown in Figures 6a & 6b. Run rope thru eyenut as shown in Figure 2.
PAGE 6
Pull Rope Eave Cable Step 7 Figure 6c With one person holding each rope, pull the liner up in unison until the ridge tubes are above the eave line. Tie ropes off to bottom of upright as shown in Figure 7b. Liner being raised. Figure 7a Figure 7b Step 8 At eave line, hook liner eave hooks to eave cable as shown in Figure 8. After all hooks are connected, raise liner to final position and tie off as shown in Figure 7b. Eave beam Eave cable View looking up at eave.
PAGE 7
Gable end eave beam.. Figure 9a Kedared buckles inserted into bottom channel of rafter at gable end awaiting gable end liner for connection. dg e Before assembling rafters to frame, kedared buckles must be inserted into the bottom channel of the rafters. Examine the gabled end liner that fits to the particular rafter.
PAGE 8
EVANSVILLE, INDIANA PHONE NUMBER 812· 867· 2421 FAX NUMBER 812· 867· 0547 Anchor products are of superior design and operate best within the parameters of these instructions. It is imperative that the instructions be carefully read and COMPLETELY FOLLOWED. Please read installation instructions before the installation or removal of this product. Installation instructions are available online at www.anchorinc.com or by calling 1-800-544-4445. CAUTION: 1.