Please use this drawing with the attached 30' Century Frame Instructions for installation of the 20' x 30' Century Frame.
Assembly Instructions Century Frame ® Tent System 30’ x 30’ Tent with Optional Walls SALES OFFICES: 1100 BURCH DRIVE PO BOX 3477 EVANSVILLE, IN 47733 USA PHONE: 812-867-2421 FAX: 812-867-0547 1-800-544-4445 EMAIL: tents@anchorinc.com www.anchorinc.com PRODUCTION FACILITY: EVANSVILLE, IN Please read all assembly / installation instructions before the installation or removal of this product.
Quantities will be different for 20' x 30' Century Frame. See drawing at the beginning of these instructions.
Century Frame Extrusion Wall Hangs in Bottom Outside Channel. Wall Channel on Bottom outside of beam. Note: Braces must be above cables.
Tab Place curtain web through triangle ring at end of tab as shown. Fasten upper hook of tension strap to curtain web. Insert lower hook into slot in upright. Triangle Ring Use ratchet to take up slack in web. This prevents uprights from sliding off weldment when other side of tent is raised. Do not tension at this time. Curtain Web Ratchet Tension Strap Repeat at other uprights in similar fashion.
7 ADJUST CENTER POLE Center Poles must be adjusted to the height on the illustration below. Turn the top of the center pole in the direction noted to meet the required dimension. (As marked on center pole) CENTER POLE PIN Carefully position center 14’-3” pole pin through pole Minimum hole in top. Use caution to prevent tearing of fabric. Raise top by pushing pole on the upper cable. Slide pole along cable until at intersection of both cables.
10 FASTEN FIESTA STRAPS AND BUCKLES (LOCATED BETWEEN UPRIGHTS) Pull straps out so that they are not caught behind eave bars. Insert the wire hook attached to the strap into the upper outside channel of the eave beam as shown in the illustrations. Make sure strap and buckle are straight and in-line. Run the end of the strap up through the fiesta buckle and pull strap until wire hook stays in place. Do not tighten at this time.
13 TENSION TOP A firmly tensioned top is required for proper installation. Pull fabric tightly and smoothly to minimize water pooling, wind damage, fabric shifting. Use ratchets on tension straps to tension the top (See Step 6). Now tighten all eight of the fiesta straps spaced between the uprights (See Step 10). Ratchet 14 TAKE DOWN 1. Remove guy webs and stakes. 2. Loosen tension straps. 3. Reverse installation steps.
EVANSVILLE, INDIANA Thank you for purchasing an Anchor product. In return, we pledge Quality, Service and Craftsmanship and are available for any questions you may have or assistance you may need. PHONE NUMBER 812-867-2421 FAX NUMBER 812-867-0547 Anchor products are of superior design and operate best within the parameters of these instructions. It is IMPERATIVE that the instructions be carefully read and COMPLETELY FOLLOWED.
