Instructions / Assembly

Faucet connection
pieces mapping
4
Installation
1. Faucet Installation
1) While selecting location for faucet, make sure faucet base sits flat
against the surface at the selected location so the gasket will seal, and
the faucet stud is accessible from below.
2) Slide Escutcheon chrome plate and large rubber gasket onto stem of
faucet and place faucet onto sink with stem going through the hole.
3) Place small rubber gasket, plastic washer, metal ss washer and star
lock washer over threaded stem of faucet and tighten locking nut from
under the counter surface to lock faucet into place.
4) Depending on tube connectors included, follow instructions below:
- Insert compression nut, plastic ferrule & tube insert into the blue
tubing (see image (a) below). Now insert this end to faucet stem
hole from under the counter and tighten with compression nut.
- OR -
- Insert the blue tubing to the quick connector (see image (b) below)
and screw it on the faucet stem.
5) Other end of blue tubing from the faucet connects OUT of filter
assembly. See image on page 6.
(b)(a)