User Manual

MADE IN USA
SIX YEAR WARRANTY
MegaVox Pro Public Address System Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
ANCHOR AUDIO CUSTOMER SERVICE
800.262.4671
FOR ADDITIONAL INFORMATION
visit www.anchoraudio.com
9
HAVING TROUBLE WITH YOUR PA SYSTEM?
CONDITION POSSIBLE CAUSE
No Sound
(power LED = OFF) • power switch is in OFF position
• batteries are fully discharged - LED may flash briefly
Charge Indicator Not On • confirm proper charger - replace if necessary
No Sound
(power LED = ON) • no output from source
• input cable unplugged or
• input volume control is low or off
Shortened Battery Life • short in external speaker cable or speaker
• total external speaker impedance < 8Ω
• battery is not fully charged or need to be replaced
Distorted Sound • poor connection on input cable
• input signal too strong
Excessive Hum or Noise • input cable not shielded
HAVING TROUBLE WITH YOUR WIRELESS SYSTEM? (WIRELESS MODELS ONLY)
CONDITION POSSIBLE CAUSE
No Sound
(RX ON Indicator = ON) • wireless volume control is to low or off
• no mic plugged into belt-pack transmitter
No Sound
(RX ON Indicator = OFF) • sound system not turned on
• transmitter power switch turned off
• low battery or no battery in transmitter
• transmitter and receiver are not on the same channel
NEED MORE HELP? MegaVox Pro PA Setup & Operation Videos!
Visit Our Website: www.anchoraudio.com
MEGAVOX PRO TECHNICAL SPECIFICATIONS
(Specifications Subject to Change Without Notice)
Rated Peak Power 20 watts
Max SPL @ Rated Power 119 dB @ 1 meter
Frequency Response 400 Hz – 10 kHz
Charger (RC-6000) 18V DC/universal input
(100Vac – 240Vac, 50 – 63Hz)
Battery 12 volt rechargeable, 5 AH
Dimensions (HWD) 13” x 9” x 14” (33 x 23 x 36 cm)
Weight 15 lbs / 6.8 Kg
Inputs
Line Hi-Z, unbalanced, 1/4”-phone
Mic 1 Lo-Z, unbalanced, 1/4”-phone
(used for wireless on
MEGA-6000U1)
Mic 2 Lo-Z, unbalanced, 1/4”-phone
Outputs
Line (post fader) Lo-Z, 1/4”-phone
Speaker Out 4Ω, unswitched, 1/4”-phone