User`s manual

AIR B-Smart BoosterPack – User’s Manual Page 8 of 33
Release Date 11/04/13
2.1. Hardware Installation
2.1.1. MSP-EXP430G2 LaunchPad Only
The following steps need to be performed on the MSP-EXP430G2 LaunchPad:
1) Remove the TXD and RXD jumpers from J3.
2) Ensure the VCC jumper is populated on J3. Jumpers RST and TEST also need to be
installed when programming the microcontroller or when debugging firmware.
3) Continue installation by following the steps provided in Section 2.1.2.
Figure 3 –MSP-EXP430G2 LaunchPad
UART RXD and TXD
jumpers removed
from LaunchPad J3.