User`s manual

AIR B-Smart BoosterPack – User’s Manual Page 21 of 33
Release Date 11/04/13
 J2 – LaunchPad Interface
Table 11 - J2 BoosterPack Connector Pinout
Pin
Signal Name
I/O
Description
J2-1
GND
-
Ground reference
J2-2
LP_J2.2
-
Not Used
J2-3
LP_J2.3
-
Not Used
J2-4
LP_J2.4
-
Not Used
J2-5
LP_J2.5
-
Not Used
J2-6
LP_J2.6
-
Not Used
J2-7
LP_J2.7
-
Not Used
J2-8
LP_J2.8/RTS_B
O
UART Request To Send
(LaunchPad MCU)
-
Not Used
(onboard MSP430 or ext MCU connected to J8)
J2-9
LP_J2.9/CTS_B
I
UART Clear To Send
(LaunchPad MCU)
-
Not Used
(onboard MSP430 or ext MCU connected to J8)
J2-10
LP_J2.10
-
Not Used
 J3 – LaunchPad Interface
0.1” pitch thru-hole footprint for adding 10-pin socket. The signals on this connector are
not used by the BoosterPack and the connector is therefore intended to be used as a
pass-thru only. Not populated (default).
 J4 – LaunchPad Interface
0.1” pitch thru-hole footprint for adding 10-pin socket. The signals on this connector are
not used by the BoosterPack and the connector is therefore intended to be used as a
pass-thru only. Not populated (default).