User`s manual

AIR B-Smart BoosterPack – User’s Manual Page 19 of 33
Release Date 11/04/13
 MCU UART Pin Mapping
The BoosterPack board provides the ability to remap the MCU UART hardware flow
control signals to support different LaunchPads. JP3 selects whether the P0_4/CTS
signal is connected to J1-8 or J2-8. Similarly, JP4 selects whether the P0_5/RTS signal
is connected to J1-9 or J2-9. Refer to the Emmoco Em-Ware Wiki (see section 2.2) for
details regarding the required jumper settings for the specific LaunchPad used.
Table 8 – JP3 Jumper Settings (CTS Select)
Jumper
Position
Description
JP3
1-2
P0_4/CTS is connected to J1-8 (default)
2-3
P0_4/CTS is connected to J2-8
Table 9 – JP4 Jumper Settings (RTS Select)
Jumper
Position
Description
JP4
1-2
P0_5/RTS is connected to J1-9 (default)
2-3
P0_5/RTS is connected to J2-9