User manual

Page 12 of 26 A2500R24x – Users Manual
Release Date 01/10/11
2. Product Approvals
The A2500R24C and A2500R24A have been designed to meet most national regulations for
world-wide ISM-band use. In particular the radio modules have been certified to the following
standards.
2.1. USA (Federal Communications Commission, FCC, )
The A2500R24A, with integrated antenna, as well as the A2500R24C, used with the antennae
listed in Table 1 below, have been tested to comply with FCC CFR47 Part 15 sub-part C
“Intentional Radiators. The devices meet the requirements for modular transmitter approval as
detailed in FCC public notice DA 00-1407 Released: June 26, 2000. The A2500R24A and
A2500R24C module can be integrated into a finished product with obtaining subsequent FCC
approvals.
(15.19a3) The modules comply with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Table 1 Approved Antennae
Item Part Number Manufacturer Type Gain
1 Integral part of A2500R24A Anaren Integral Antenna 2
2 66089-2406 Anaren Monopole whip, 6mm lead 3
3 66089-2430 Anaren Monopole whip, 30mm lead 3
4 66129-2480 Anaren Patch. 80mm lead 5
2.1.1. FCC Labeling Requirements
The A2500R24A and A2500R24C modules have been labeled with their own FCC ID number
and if the FCC ID is not visible when the module is installed inside another device, then the
outside of the finished product into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:
Anaren
FCC ID: X7J-A10030501