MSDS

Section VII ---- Precautions for Safe Handling and Use
Steps to be taken in case Material is Released or Spilled Special Precautions: Use good housekeeping practices to prevent accumulation of dust
and to keep airborne dust to a minimum.
Waste Disposal Method Do not incinerate. Dust, etc. – follow federal, state, and local regulations regarding disposal.
Precautions to Be Taken in Handling and Storing; Not to be stored near open flame. Not to be stored in areas where the temperature exceeds
150˚F.
Other Precautions; None during normal use
Section VIII ---- Control Measures
Respiratory Protection (Specify Type)
Approved dust/mist/fume respirator should be used during welding or burning if OSHA PEL or TLV is exceeded.
Ventilation Local Exhaust SPECIAL
As needed to remove fumes
None
Mechanical (General) Other
As needed to remove fumes and/or dust
None
Protective Gloves;
Eye Protection;
When welding or burning. Safety glasses should always be worn when grinding or cutting;
Other Protective Clothing or Equipment; As required
Work/Hygienic Practices; Normal safety and hygiene practices.
Section IX ---- Additional Information
This product has been determined to be RoHS and REACH compliant from current information available.
Disclaimer:
The information in this MSDS was obtained from sources which we believe are reliable. However, the information is provided without any representation or
warranty, expressed or implied regarding the accuracy or correctness.
The conditions or methods of handling, storage, use and disposal of the product are beyond our control and may be beyond our knowledge. For this and
other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the
handling, storage, use or disposal of the product. Disposal; this product may be recycled as separate components.
PAGE 3
* U.S.G.P.O.; 1986-491-529/45775