User's Manual

32
CONNECTING TO A WIRELESS NETWORK:
Wi-Fi PROTECTED SETUP (WPS)
Wi-Fi Protected Setup (WPS) is a feature found
on most wireless routers that allows your
soundbar product to securely and automatically
connect without needing to enter a password.
WPS is not a standard feature on all routers,
and only one wireless device can be set up at
a time.
Check your router’s owner’s manual to see if
WPS is an available feature, or look for a button
on your router marked with the WPS logo ( ).
If your router does not have WPS, then use the
Access Point Wireless Setup.
1. For optimal setup conditions place your
soundbar next to your wireless router. The
soundbar can be moved to its final location
after Wi-Fi setup
2. Plug in your soundbar and press the Power
button.
3. The Wi-Fi Status LED will start rapidly
blinking for 20 seconds while your
soundbar boots. If this is the first time
your new soundbar is plugged in, the Wi-Fi
Status LED will start pulsing slowly. If the
soundbar is already configured to connect
to a Wi-Fi network, the LED will turn solid
(connected) or blink rapidly (not connected).
4. For 3 seconds, press the soundbar’s Wi-Fi
Setup Button until you hear a tone. After a
few seconds the Wi-Fi Status LED will blink
twice in continuous intervals to indicate
WPS mode. You can also choose “Wireless
Setup > Push Button Setup” from the
soundbar menu to enter WPS Setup Mode.
At any time you can press the Wi-Fi Setup
button again to cancel the setup mode.
5. Now push the WPS button ( ) on your
router.
6. Once the Wi-Fi Status LED is solid (not
blinking), this indicates your soundbar is
connected to the wireless network. This
may take up to a minute. If, after a minute,
the button continues to blink rapidly, setup
failed and you should try again.
7. Connect your mobile device or PC to the
same network as your soundbar. Launch
the DTS Play-Fi
®
app. Upon launching, it
will automatically detect your soundbar and
should prompt you to name your soundbar.
CONNECTING TO A WIRED NETWORK
1. Using an Ethernet cable, connect your
soundbar to your router.
2. Plug in your soundbar and press the Power
button.
3. The Wi-Fi Setup and Status button will start
rapidly blinking for about 20 seconds while
your soundbar is booting up.
4. The Wi-Fi Setup and Status button turns
off when the soundbar is connected via
Ethernet.
5. Connect your mobile device or PC to the
same network as your soundbar. Launch
the DTS Play-Fi app. Upon launching, it will
automatically detect your soundbar and
should prompt you to name your soundbar.
Paradigm PW Soundbar Manual 102016.indd 32 2016-10-20 9:16 AM