User's Manual

31
soundbar boots. If this is the first time
your new soundbar is plugged in, the Wi-Fi
Status LED will start pulsing slowly. If the
soundbar is already configured to connect
to a Wi-Fi network, the LED will turn solid
(connected) or blink rapidly (not connected).
4. Once the Wi-Fi Status LED starts pulsing
slowly, your soundbar is in Access Point
Mode and ready to connect to your wireless
network. Note: If the soundbar’s Wi-Fi
Status LED is not pulsing slowly, press and
hold the W-Fi Setup button for 8 seconds
until you have heard two tones—one at 3
seconds and another at 8 seconds. You can
also choose “Wireless Setup > From Play-Fi
App” from the soundbar menu to enter
Access Point Mode. After 20 seconds, the
Wi-Fi Status LED will begin pulsing slowly
to indicate Access Point mode is ready. At
anytime you can press the button again to
cancel the setup mode.
5. Launch the DTS Play-Fi
®
app.
Android Device Users:
a) The app will automatically find your device
and provide prompts for setup.
b) Touch the “Setup” button on the screen.
c) Enter the password for your wireless
network; the app will connect your device
to your network.
d) Once your device is connected, you will
notice that the Wi-Fi Status LED on your
soundbar will change from blinking to
solid. This may take up to a minute. If, after
a minute, the button continues to blink
rapidly, setup failed and you should try
again.
iOS Device Users:
Please note: When using an iOS device your
soundbar can stream audio using either
Apple AirPlay or DTS Play-Fi.
a) Make sure your iOS device’s Wi-Fi is turned
on and connected to your Wi-Fi network.
b) Open your iOS device’s ‘Settings’ app and
go to the ‘Wi-Fi’ menu. Your soundbar will
show up under the heading ‘set up new
airplay speaker...’
c) Select your soundbar from the list. It will
have “Play-Fi ” in the name.
d) Once in the ‘AirPlay Setup’ menu you will be
prompted to select your Wi-Fi network and
name your soundbar (you will not need to
enter your network password).
e) Once your soundbar is connected, you will
notice that the Wi-Fi Status LED on your
will change from blinking to solid. This may
take up to a minute. If, after a minute, the
LED continues to blink rapidly, setup failed
and you should try again.
f) Your soundbar is now connected to your
wireless network. Reconnect your iOS
device to your wireless network.
PC Users:
a) The app will automatically find your device
and provide prompts for set up. If the app
does not prompt you to set up a new device,
within the app go to the settings screen and
click ‘Setup Play-Fi Device’. Follow the on-
screen instructions.
b) Click the “Set-up” button on the screen.
c) Select the speaker(s) you want to set up.
d) Enter the password for your wireless
network; the app will connect your device
to your network. You will notice the Wi-Fi
Status LED will have changed from blinking
to solid. This may take up to a minute. If,
after a minute, the button continues to
blink rapidly, setup failed and you should try
again.
6. Your soundbar is now connected to your
wireless network. Reconnect your mobile
device or PC to your wireless network. You
may re-name your device using the app
Paradigm PW Soundbar Manual 102016.indd 31 2016-10-20 9:16 AM