User's Manual

27
• Input: Bluetooth
• Input: Optical 1
• Input: Optical 2
• Input: Analog 1
• Input: Analog 2
• ARC On [Anthem Room Correction On]
• ARC Off [Anthem Room Correction Off]
Choose the command you want to program
and press the enter button. The soundbar will
respond with ‘Push Button’. Hold the second
remote approximately 12 inches (30cm) from
the soundbar and press the appropriate but-
ton four times. If the new command is learned
successfully, the soundbar’s display will display
“Saved”. If the new command is not learned,
the soundbar will display “Failed”. Repeat the
process if learning fails.
Learn > Reset Remote: Enter the submenu by
pressing the enter button. Erasing will clear
programming for the second remote. The Reset
function requires confirmation.
Learn > Reset Remote > No: Activate by press-
ing the enter button. Choosing this option will
exit without erasing the remote programming.
Learn > Reset Remote >Yes: Activate by press-
ing the enter button. The soundbar will respond
with ‘Resetting’. After codes are reset, there is
no way to recover the previous settings.
MENU OPTION: SOURCE NAME
Source Name: Enter the submenu by pressing
the enter button. The settings in this menu will
allow you to assign new names to display
on the soundbar when changing inputs. For
example, you can program the ‘Optical 1’ input
to display ‘DVD’.
Using the up/down directional buttons, you can
select and program the following input names:
• HDMI 1
• HDMI 2
• HDMI 3
• HDMI ARC
• Bluetooth
• Optical 1
• Optical 2
• Analog 1
• Analog 2
Choose the input name you want to reprogram
and press the enter button. The soundbar dis-
play will display the current name. Pressing
the up/down directional buttons will cycle
through the available alpha-numeric charac-
ters. Pressing the left/right directional buttons
will move to the next/previous space. To finish
programming an input name, use the left/right
buttons to move all the way to the left or right.
MENU OPTION: SERVICE
Service: Enter the submenu by pressing the
enter button.
Service > Firmware: Enter this submenu by
pressing the enter button.
Service > Firmware > MCU: Pressing the enter
button will display the current firmware version
for the soundbar’s MCU (microcontroller unit).
Service > Firmware > DSP: Pressing the enter
button will display the current firmware version
for the soundbar DSP module.
Service > Firmware > IA3S4: Pressing the enter
button will display the current firmware version
for the soundbar’s wireless subwoofer module.
Paradigm PW Soundbar Manual 102016.indd 27 2016-10-20 9:16 AM