User's Manual

25
off. Activate by pressing the enter button and the
soundbar will respond with ‘Saved’. Please note,
turning ARC on and off only makes a difference
if ARC corrections have not been loaded on the
soundbar.
MENU OPTION: POWER SETTINGS
Power Settings: Enter the submenu by pressing the
enter button. Here you may adjust the soundbar’s
power options.
Power Settings > Power Standby: Enter the sub-
menu by pressing the enter button. Here you choose
whether the subwoofer is always on or turns itself on
and off automatically.
Power Settings > Power Standby > Auto Standby
(Default): This option configures the soundbar to turn
itself off after no audio signal is detected for approxi-
mately 20 minutes. When the soundbar detects an
audio signal, it will immediately turn itself on. Activate
by pressing the enter button and the soundbar will
respond with ‘Saved’. Please note: When set to Auto
Standby, if the soundbar is manually turned off (using
the power button on the control panel or remote
control), the soundbar will not respond to an incoming
audio signal and will not turn on automatically. In this
situation, turn the soundbar on using the power button
on the control panel or remote control and the sound-
bar will resume automatic power handling.
Power Settings > Power Standby > Always On: This
option configures the soundbar to remain on at all
times until it is manually turned off using the power
button on the control panel or remote control. Activate
by pressing the enter button and the soundbar will
respond with ‘Saved’.
Power Settings > Power-On Volume: Enter the
submenu by pressing the enter button. Here you can
configure the default volume of the soundbar when it
powers on or comes out of standby.
Power Settings > Power-On Volume > Set: Enter
the submenu by pressing the enter button. Here you
choose set the power-on volume.
Power Settings > Power-On Volume > Set > –90dB to
+10dB: Using the up/down directional buttons, choose
the desired volume level. Once set the soundbar will
always be set to this level when it powers on or comes
out of standby. The default level is –35dB.
Power Settings > Power-On Volume > Last Used:
When Power Standby is set to “Last Used”, the sound-
bar will power on or come out of standby at a volume
level matching the volume setting when it was pow-
ered off or went into standby.
Power Settings > IP Control: Enter the submenu by
pressing the enter button. Here you can turn IP Control
off or on. IP Control allows the soundbar to respond to
incoming IP commands from networked home control
systems connected via Ethernet or Wi-Fi.
Power Settings > IP Control > Off or On: This option
turns the IP Control feature off or on. Activate by
pressing the enter button and the soundbar will
respond with ‘Saved’.
Power Settings > Standby IP: Enter the submenu by
pressing the enter button. Here you can turn Standby IP
Control off or on. This allows you to configure how the
soundbar responds to incoming IP commands when it is
in standby mode.
Power Settings > Standby IP > Off or On: This option
turns the Standby IP Control feature off or on. Activate
by pressing the enter button and the soundbar will
respond with ‘Saved’. When this setting is set to “Off”
the soundbar will not respond to incoming IP com-
mand when it is powered off or in standby mode. If IP
Control is set to Off, Standby IP Control is disabled.
Paradigm PW Soundbar Manual 102016.indd 25 2016-10-20 9:16 AM