User's Manual

27
feature on or off. Activate by pressing the enter but-
ton and the soundbar will respond with ‘Saved’.
Please note, turning ARC on and off only makes a
difference if ARC corrections have not been load-
ed on the soundbar.
MENU OPTION: POWER SETTINGS
Power Settings: Enter the submenu by pressing
the enter button. Here you may adjust the sound-
bar’s power options.
Power Settings > Power Standby: Enter
the submenu by pressing the enter button. Here
you choose whether the subwoofer is always on or
turns itself on and off automatically.
Power Settings > Power Standby > Auto
Standby: This option configures the soundbar to turn
itself off after no audio signal is detected for approxi-
mately 20 minutes. When the soundbar detects an
audio signal, it will immediately turn itself on. Activate
by pressing the enter button and the soundbar will
respond with ‘Saved’. Please note: When set to Auto
Standby, if the soundbar is manually turned off (using
the power button on the control panel or remote con-
trol), the soundbar will not respond to an incoming
audio signal and will not turn on automatically. In this
situation, turn the soundbar on using the power button
on the control panel or remote control and the sound-
bar will resume automatic power handling.
Power Settings > Power Standby
> Always On: This option configures the
soundbar to remain on at all times until it is
manually turned off using the power button
on the control panel or remote control. Activate
by pressing the enter button and the soundbar will
respond with ‘Saved’.
Power Settings > Power-On Volume: Enter
the submenu by pressing the enter button. Here you
can configure the default volume of the soundbar
when it powers on or comes out of standby.
Power Settings > Power-On Volume >
Set: Enter the submenu by pressing the enter but-
ton. Here you choose set the power-on volume.
Power Settings > Power-On Volume >
Set > –90dB to +10dB: Using the up/down
directional buttons, choose the desired volume
level. Once set the soundbar will always be set
to this level when it powers on or comes out of
standby. The default level is –35dB.
Power Settings > Power-On Volume >
Last Used: When Power Standby is set to “Last
Used”, the soundbar will power on or come out of
standby at a volume level matching the volume set-
ting when it was powered off or went into standby.
Power Settings > IP Control: Enter the
submenu by pressing the enter button. Here you
can turn IP Control off or on. IP Control allows the
soundbar to respond to incoming IP commands
from networked home control systems connected
via Ethernet or Wi-Fi.
Power Settings > IP Control > Off or
On: This option turns the IP Control feature off or
on. Activate by pressing the enter button and the
soundbar will respond with ‘Saved’.
Power Settings > Standby IP Control: Enter
the submenu by pressing the enter button. Here you
can turn Standby IP Control off or on. This allows
you to configure how the soundbar responds to
incoming IP commands when it is in standby mode.
Power Settings > Standby IP Control >
Off or On: This option turns the Standby IP Control
feature off or on. Activate by pressing the enter but-
ton and the soundbar will respond with ‘Saved’.
When this setting is set to “Off” the soundbar will