User manual

Configuration

2.5.2. Connecting the digital outputs

The outputs are implemented as open collector drivers. If a output is active, it is pulled down to GND. In

the inactive condition the output is floating.

In principle the maximum current of each individual output is 400mA. For thermal reasons is the sum

of all output currents is limited to 500mA. The outputs not short-circuit proofed, and must be protected

with a pre-resistor.

2.6. Firmware update

Use the Firmware page to load a new firmware to the AnaGate CAN Gateway.

Please visit our Web site http://www.anagate.de for further information.

2.7. Factory reset

In order to restore the default factory settings, hold the RESET for approx. 10 seconds. If the device is

reset successfully, the yellow LED blinks until the RESET is released.

The default factory settings are activated immediately without a restart of the device:

IP address 192.168.1.254

Address type static

Network mask 255.255.255.0

Gateway 192.168.1.1

Important

If the RESET push-button is pressed too briefly, the actual IP address and network mask

is pulsed via the yellow LED (Morse code). A second push of the RESET, terminates the

pulsing, the device is not reset.

Note

The factory reset is not possible directly after power on until complete loading of operating

system and firmware of the device. This initialization period is signalled via the yellow

activity LED. On power on the LED is switched on and after initialization the LED is

switched off.

Note

Maybe the ARP cache of the PC has to be deleted to find the device with the changed IP

address.

2.7.1. Examining the network settings

It is possible to check the current network settings directly on the device.

After pressing shortly the RESET button the device starts to pulse out the current n settings via the yellow

activity LED. Pressing again the buttons stops the pulsing immediately.

The IP address and subnet mask are pulsed out, one after the other. Following pulse codes are used: