User manual

Configuration

Figure 2.3. HTTP interface, CAN settings

Baudrate The baud rate can be selected easily via a list box containing all supported

values.

Termination Use the check box to switch on/off the internal termination resistor.

High Speed Activates/deactivates the Highspeed mode. In this operating mode all

incoming/outgoing CAN telegrams are not longer confirmed by the opposite

LAN side to accelerate process throughput. Software-Filters are switched off

too in this mode.

Bridge Activates/deactivates the bridge mode (see Section 3.2, “ Bridge mode”).

to IP IP address of the partner device, to which a connection (bridge) is to be made

(only Bridge Modus).

at Port Port of the partner device, to which a connection (bridge) is to be made (only

Bridge Modus).