User manual

Configuration

2.2. Network settings

On the page IP Settings the following settings can be changed.

DHCP Here you can switch between static IP and dynamic (via DHCP) addresses. If DHCP

is being used, the remaining fields are ignored, because this information is retrieved

from the DHCP server.

In this case, a DHCP server must be available and accessible in the network.

IP address The IP address of the AnaGate CAN Gateway is entered in a.b.c.d format (e.g.

192.168.1.200).

Subnet mask The subnet mask is entered in a.b.c.d format (e.g. 255.255.255.0).

Gateway The default gateway is entered in a.b.c.d format (e.g. 192.168.1.1). Leave blank or

enter 0.0.0.0 if a default gateway is not required.

Figure 2.2. HTTP interface, network settings

The inputs will be taken over immediately after clicking the button Save settings and saved

permanently on the AnaGate CAN Gateway. A restart of the device is not necessary for activation of the

settings.

Note

Maybe the ARP cache of the PC has to be deleted to find the device with the changed IP

address.

2.3. CAN settings

On the page CAN Settings the global settings for all existing CAN interfaces are displayed and can be

changed individually.