User manual

Description

1.4.2. AnaGate CAN quattro - rear view

Figure 1.2. AnaGate CAN quattro, back panel

The rear panel of the AnaGate CAN Gateway features the following connectors and LEDs (from left to

right):

Power LED This green LED lights up when voltage is being supplied.

Power supply The AnaGate CAN Gateway can be power supplied in two different ways.

For the use as desktop device the barrel connector socket is intended, in order to supply

the device via a plug power supply

For the use in a switchboard the two-pole Wago clamping socket can be used to

connect an external power supply.

Warning

Be sure to use only one power supply.

LAN Via the RJ45 socket the AnaGate CAN Gateway is connected with the Ethernet. The

device can be connected to a network component like a hub or a switch. For a direct

connection to a PC a crossover network cable has to be used.

USB Hosts The AnaGate CAN Gateway has two USB 1.1 interfaces for further extensions or

customer specific solutions.

Digital IO The AnaGate CAN Gateway has 4 digital inputs and 4 digital outputs which can be

used freely. The digital io are galvanically decoupled from the device and must be

externally power supplied from 3,3V to 24V (see Section 2.5, “ Digital IO”).

Reset The AnaGate CAN Gateway can be reset to the factory settings using this button (see

Section 2.7, “ Factory reset” for further details).

Activity LED This yellow LED lights up when the AnaGate CAN Gateway is processing incoming

CAN messages.