User manual

Configuration

Warning

The outputs are not short-circuit-safe!

2.8. Factory reset

In order to restore the default factory settings, hold the RESET for approx. 10

seconds. If the device is reset successfully, the yellow LED blinks until the RESET

is released.

The default factory settings are activated immediately without a restart of the device:

IP address 192.168.1.254

Address type static

Network mask 255.255.255.0

Gateway 192.168.1.1

Important

If the RESET push-button is pressed too briefly, the actual IP address and

network mask is pulsed via the yellow LED (Morse code). A second push

of the RESET terminates the pulsing, the device is not reset.

Note

The factory reset is not possible directly after power on until complete

loading of the operating system and the firmware of the device. This

initialization period is signalled via the yellow activity LED. On power on

the LED is switched on and after initialization the LED is switched off.

Note

Maybe the ARP cache of the PC has to be deleted to find the device with

the changed IP address.

2.8.1. Examining the network settings

It is possible to check the current network settings directly on the device.

After pressing shortly the RESET button the device starts to pulse out the current

n settings via the yellow activity LED. Pressing again the buttons stops the pulsing

immediately.

The IP address and subnet mask are pulsed out, one after the other. Following pulse

codes are used:

• Digits 1, 2, 3, ...., 9: 1x, 2x, ...9x Flashing (200ms delay between each flash)

• Digit 0: 10x flashing (200ms delay between each flash)

• Dot: 1x very fast flash