User manual

Configuration

Figure 2.4. HTTP interface, CAN settings

Reception timer interval This value specifies the frequency which is used

to examine if new CAN telegrams are available in

the internal driver buffer. The more frequently this

examination is done, the shorter is the latency of

the re-transmission of the CAN data via ethernet. On

the other hand, its maximum message throughput is

decreased.

The interval is defined in micro seconds, default value

is 3000. To give control immediately to the firmware

after a CAN telegram is received by the CAN driver,

the value 0 has to be set.

The inputs will be taken over immediately after clicking the button Save settings

and saved permanently on the AnaGate CAN Gateway. A restart of the device is not

necessary for activation of the settings.

2.5. Device status

On the page Status the device dependand status information is shown.