User manual

Chapter 2. Configuration

2.1. Initial installation

First the AnaGate CAN Gateway must be supplied via the power plug with a tension

from 9 to 24 V.

Insert the included LAN cable into the plug labelled LAN and connect it either to a

hub or switch. If connecting directly to a PC use a crossover LAN cable (not in scope

of delivery) instead of the included LAN cable.

2.1.1. Factory settings

The AnaGate CAN Gateway is delivered with the following initial network settings:

IP address 192.168.1.254

Address type static

Network mask 255.255.255.0

Gateway 192.168.1.1

The device can now be configured using a standard browser (Internet Explorer,

Firefox, etc.) by using http://192.168.1.254 .

Figure 2.1. HTTP interface, AnaGate CAN duo

Note

The PC used for the configuration must be in the 192.168.1.x network.

The static IP address 192.168.1.2 with the subnet mask 255.255.255.0