User manual

Description

1.4.2. AnaGate CAN duo - rear view

Figure 1.2. AnaGate CAN duo, back panel

The rear panel of the AnaGate CAN Gateway features the following connectors and

LEDs (from left to right):

Power LED This green LED lights up when voltage is being supplied.

Power supply The AnaGate CAN Gateway can be power supplied in two different

ways.

For the use as desktop device the barrel connector socket is

intended, in order to supply the device via a plug power supply

For the use in a switchboard the two-pole Wago clamping socket can

be used to connect an external power supply.

Warning

Be sure to use only one power supply.

LAN Via the RJ45 socket the AnaGate CAN Gateway is connected with

the Ethernet. The device can be connected to a network component

like a hub or a switch. For a direct connection to a PC a crossover

network cable has to be used.

USB Hosts The AnaGate CAN Gateway has two USB 1.1 interfaces for further

extensions or customer specific solutions.

Digital IO The AnaGate CAN Gateway has 4 digital inputs and 4 digital outputs

which can be used freely. The digital io are galvanically decoupled

from the device and must be externally power supplied from 3,3V

to 24V (see Section 2.7, “ Digital IO”).

Reset The AnaGate CAN Gateway can be reset to the factory settings using

this button (see Section 2.8, “ Factory reset” for further details).

Activity LED This yellow LED lights up when the AnaGate CAN Gateway is

processing incoming CAN messages.