User manual

Configuration

offline The CAN controller is not active on the

CAN bus (offline).

normal Normal operating mode. The default

setting of CAN baud rate is used.

listen In listen mode the CAN controller is

passive. CAN messages are received, but

no messages can be sent (no ACK, no

error). The default setting of CAN baud

rate is used.

loopback In loopback mode every sent CAN

message is mirrowed back by the CAN

controller (no ACK, no errors). The default

setting of CAN baud rate is used.

A more detailed description of the operating modes

can be found in the data sheet of the CAN controller

(Microchip MCP2515).

Bridge Activates/deactivates the bridge mode (see

Section 3.2, “ Bridge mode”).

to IP IP address of the partner device, to which a

connection (bridge) is to be made. The IP address has

to be entered in dot notation. A domain name can

be entered only if a name server is entered in the IP

settings (see Section 2.2, “ Network settings”). (only

Bridge Modus).

at Port Port of the partner device, to which a connection

(bridge) is to be made (only Bridge Modus).

Remote-Baudrate Baudrate of the partner device, to which a connection

(bridge) is to be made (only Bridge Modus).

Remote-Termination Terminierung of the partner device, to which a

connection (bridge) is to be made (only Bridge

Modus). On destination devices, which can not

software-configure the CAN bus termination (like the

CAN X2/X4/X8), this setting is ignored.

The inputs will be taken over immediately after clicking the button Save settings

and saved permanently on the AnaGate CAN Gateway. A restart of the device is not

necessary for activation of the settings.

2.4. Advanced settings

On the page CAN Settings the advanced settings of the unit are displayed and can

be changed individually.