User manual

Configuration

can be e.g. used. If neccessary the settings of the network interface on

the configuration pc has to be changed temporarily.

2.2. Network settings

On the page IP Settings the following settings can be changed.

DHCP Here you can switch between static IP and dynamic (via DHCP)

addresses. If DHCP is being used, the remaining fields are ignored,

because this information is retrieved from the DHCP server.

In this case, a DHCP server must be available and accessible in the

network.

IP address The IP address of the AnaGate CAN Gateway is entered in dot format

(e.g. 192.168.1.200).

Subnet mask The subnet mask is entered in dot format (e.g. 255.255.255.0).

Gateway The default gateway is entered in dot format (e.g. 192.168.1.1).

Leave blank or enter 0.0.0.0 if a default gateway is not required.

Name Server The IP adress of a name server, which resolves domain names (in

dot format). If a name server is set, the end point of a IP bridge can

be entered as domain name (see Section 2.3, “ CAN settings”).

Local domain Local domain name. Most queries for names within this domain can

use short names relative to the local domain in the end point field

of a CAN/IP bridge. The domain part is taken to be everything after

the first '.'. Is xyz.local the local domain name, the short name

dest will extended to dest.xyz.local.

Figure 2.2. HTTP interface, network settings