User manual
Description
4 © 2007-2014 Analytica GmbH
Pin Description
1 GND
2 CAN_L
3 not connected
4 CAN_H
Table 1.2. Pin layout, CAN plug, upper
connector strip
ACT
LED
This green LED lights up when the AnaGate CAN Gateway
is processing incoming and outgoing CAN messages.
ERR
LED
This red LED lights up if the error state is in warning state
which is set if at least one of the error counters equals or
exceeds the error warning limit of 96.
The lower connector strip of the AnaGate CAN X2 features the following connectors
and LEDs (from left to right):
Fault LED Reserved for future use.
Active LED This red LED lights up when the AnaGate CAN Gateway is processing
outgoing CAN messages.
Reset The AnaGate CAN Gateway can be reset to the factory settings using
this button. (see Section 2.8, “ Factory reset” for further details)
USB Host 1,
USB Host 2
The AnaGate CAN Gateway has two USB 1.1 interface for further
extensions or customer specific solutions.
CAN port B Term Via this DIP switch the integrated CAN bus termination
can be set for each CAN port (up= OFF, down=ON).
CAN 4 pole plug to connect the CAN bus. The corresponding
connector plug is included in delivery (screw terminal up
to 1,5mm²). The pin allocation of the plug can be inferred
from the following table.
Pin Description
1 GND
2 CAN_L
3 not connected
4 CAN_H
Table 1.3. Pin layout, CAN plug, lower
connector strip