User manual

Description

1.4. Interfaces and plugs

1.4.1. AnaGate CAN X2

Figure 1.1. Top view AnaGate CAN X2

The upper connector strip of the AnaGate CAN X2 features the following connectors

and LEDs (from left to right):

LAN Via the RJ45 socket the AnaGate CAN Gateway is connected with

the Ethernet. The device can be connected to a network component

like a hub or a switch. For a direct connection to a PC a crossover

network cable has to be used.

Analog IO The AnaGate CAN Gateway has 4 analogue inputs and 4 analogue

outputs which can be used freely. The io's are not galvanically

decoupled from the device and are internally power supplied (see

Section 2.7, “ Analogue IO”).

Power supply The two-pole clamping socket can be used to connect an external

power supply.

CAN port A Term Via this DIP switch the integrated CAN bus termination

can be set for each CAN port (up=ON, down=OFF).

CAN 4 pole plug to connect the CAN bus. The corresponding

connector plug is included in delivery (screw terminal up

to 1,5mm²). The pin allocation of the plug can be inferred

from the following table.